 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
COPPER
BRUTE ENERGY SAVER
- ASME 160 lb. working
pressure heat exchanger
- 24V control system
- Operating valve/pressure regulator
- Redundant safety gas valve
- Operating control
- Manual reset high temperature
limit
- Water flow switch
- Pressure relief valve (125 PSI)
- 115/24V transformer
- Terminal strip
- On/off toggle switch
- Energy Management Monitor (EM2)
pump time delay
- Stainless steel burners
- Glass lined cast iron headers
- 2 amp fuse
- Manual Pilot Valve
- Pilot Gas Valve
- Pilot Gas Regulator
- Manual Shutoff Valve
COPPER
BRUTE II
- Thermal efficiency
up to 85%
- ASME "H" stamp, designe dand certified for
potable water use
- Pump & Flow switch, mounted
and wired
- Multiple operating gas valve/pressure
regulators
- Intake air filter
- Multiple removable burner trays
- Air pressure switch
- Burner site glass
- Automatic reset high limit
- Electronic PID staging control
with LCD and touchpad
- PC board for electrical connections
- External controller connections
with selector switch
- Hot surface ignition
- Diagnostic Lights
- Less than 10 ppm Nox
| eF SERIES HIGH EFFICIENCY
- Non-CFC foam insulation
- 99.1% thermal efficiency
- 60 Gallon in 125,000 , 150,000
and 199,999 BTU`s
- 100 Gallon in 150,000 , 199,999
, 250,000 and 300,000 BTU`s
- Versatile venting
- Electronic controls
- Premix power burner
- Submerged combustion chamber
- Zero inch clearance chamber
- Three Pass Flue System
- Vitraglas® lined tank
- Four protective magnesium anode
rods
- Hand hole cleanout
- Factory installed Hydrojet® Sediment Reduction System
- Brass drain valve
- T&P relief valve
Factory installed dielectric fittings |
| ENERGY SAVER 38 GALLON
|
|
 |
| ENERGY SAVER STORAGE TANKS
- Meets ASHRAE 90.1b
1992.
- 2" Non-CFC foam insulation..
- Factory installed T&P valve.
- Factory installed dielectric
waterway fittings
- Hand-hole cleanout
- Side T&P valve opening.
- Brass Drain Valve.
- Vitraglas® lined tank.
|
EverHot Tankless Water
Heater
- Continous Flow
- Heat Exchanger
- Remote Control
- Direct Electronic Ignition
- Very Low Noise Level
- Fully Automatic Controls
- Interior and Exterior Models
- Diagnostic Controls
- Cut Energy Waste
- Space Saving Installation
- Lime Accumulation Sensor
- Five year limited warranty on
heat exchanger
- Five year limited warranty on
parts
| FAN INDUCED
- ASME
models available
- Vitraglas lined tank
- Electronic Ignition
- Automatic Flue
Damper reduces standby loss
- 3 Magnesium anode
rods provide extra corrosion protection
- 2" Non CFC
foam insulation.
- Commercial Hydrojet®
Sediment Reduction System
- Brass Drain Valve
- Hand Hole Cleanout
- Factory Installed
T&P relief valve
- 625,000 - 725,000
BTU's
|
|
|
|
| LARGE JACKETED STORAGE TANKS
- Glass lined interior.
- High density insulation.
- Galvanized jacket.
- Built in drain pan on square
models.
- 125 PSI ASME.
- Protective magnesium anode rod.
- Square models mounted on channel
iron skid.
- 5 year tank warranty.
- ASME certified at 150 PSI
- Manhole.
- T&P gauge.
- Hand-hole cleanout.
- Lifting lugs (square models
only).
|
ENERGY
SAVER MILLIVOLT
- Millivolt Controls
- Vitraglas lined tank
- Flue Damper
- Continuous Pilot Ignition
- Handhole Cleanout
- Factory Installed T&P relief
valve
- Magnesium anode rods provide extra
corrosion protection
- Non CFC foam insulation
- ASME code available above 200,000
BTU`s
- Commercial Hydrojet®
Sediment Reduction System
- Brass Drain Valve.
| POWER BURNER
- ASME tested and
certified at 160 psi
working pressure.
- Copper lined pressure vessel
- 83% non-condensing thermal efficiency.
- Ceramic fiber combustion chamber
with bolted pressure vessel.
- ASME 3" hand hole cleanout.
- Minimum floor space.
- Heavy duty steel skids
- 150 PSI ASME T&P relief
valve
- 3" glass fiber tank insulation.
- Lifting lugs.
- 5 year limited warranty on pressure
vessel and combustion chamber.
- Upper and lower aquastats with wells.
- Automatic and manual reset high limit controls.
- Low pressure main and pilot
gas pressure regulators.
- All models meet California Energy
Commission requirements.
- Combustion flame safety control
with pre-purge.
- Safety air flow switch
- Low water cut off(s).
- Dielectric isolation kits.
|
|
|
| BRADFORD WHITE POWERSTOR SERIES
- COMMERCIAL SINGLE-WALL INDIRECT
- 2" Non-CFC
foam insulation
- Factory installed nipples
- Fully automatic controls
- Vitraglas® lining
- Factory installed Hydrojet® Total Performance System
- Supply and Return Connections
- Three protective aluminum anode
rods
- T&P relief valve installed
- 5 Year limited warranty on tank
and heat exchanger
- Brass Drain Valve
|
| PowerStor SeriesTM
Stainless Steel Indirect
- CFC free polystyrene
insulation
- Aquastat
- Stainless Steel Tank and Heat
Exchanger
- Supply and Return Connections
- Corrosion and dent resistant
jacket
- Brass Drain/Return Valve
- T&P relief valve opening
|
| Power Vent Kit
Recommended for; New Construction, Electric
to Gas Conversions, Rennovations,
Deteriorated Chimneys, Distance Installations and
Negative Draft Situations
- For models with inputs ranging
from 125,000 BTU's to 505,000 BTU's (36.6 KW to
148.0 KW)
- Temperature sensitive safety
spill switches
- For venting up to 100 feet (30
meters)
- 5 different kits available -
2 for millivolt systems,
3 for 24 volt systems
- Mounting hardware included
- 30 foot (9 meters) length wire
harness provided to ease installation
- 1 year warranty
- AGA and CGA certified for use
with either Natural or Propane Gas Models
|
POWER
DIRECT VENT - Independent Vent
- 1 1/8" Non CFC
Foam Insulation
- Automatic Blower Motor
- Lo Nox
construction available
- ASME available on 250,000 BTU
model
- Electronic Ignition
- Coaxial Vent
- Vitraglas Lined Tank
- Handhole Cleanout
- Factory Installed Temperature
and Pressure Relief Valve.
- Factory Installed Hydrojet® Total Performance System
- Brass Drain Valve.
|
|
| |
 |
|